ID-BOX Calibration / Parameter Memory Failure (B279046)
DESCRIPTION
When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
B279046 |
ID-BOX Calibration / Parameter Memory Failure |
An internal malfunction occurs in the ID code box (immobiliser code ECU) (EEPROM access malfunction) (1 trip detection logic*). |
|
DTC output confirmation operation:
|
- *: Only output while a malfunction is present.
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
|
- |
DTC No. | Data List and Active Test |
|---|---|
B279046 |
- |
NOTICE:
- When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins.
Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Start Key(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
- The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
Click here
.gif)
- Before replacing the ID code box (immobiliser code ECU), refer to Registration.
Click here
.gif)
- After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."
PROCEDURE
REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
(a) Replace the ID code box (immobiliser code ECU) with a new one.
Click here ![]()
|
CLEAR DTC
(a) Using the GTS, clear the DTCs.
Body Electrical > Smart Key > Clear DTCs
|
REGISTER RECOGNITION CODE
(a) Register the recognition codes to the ECUs.
Click here ![]()
|
REGISTER ECU COMMUNICATION ID
(a) Register the ECU communication ID codes.
Click here ![]()
|
CHECK DTC
(a) Using the GTS, check if DTC is output.
Body Electrical > Smart Key > Trouble CodesResult | Proceed to |
|---|---|
DTC B279046 is output |
A |
DTC B279046 is not output |
B |
| A | REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
| B | END (ID CODE BOX (IMMOBILISER CODE ECU) WAS DEFECTIVE) |