INSPECTION
PROCEDURE
1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
(a) Shift Paddle Switch LH (Transmission Shift Switch Assembly):
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
1 (SDN) - 2 (ECC) |
"-" (Down shift) shift paddle switch operated and held |
Below 1 Ω |
"-" (Down shift) shift paddle switch not operated |
1 MΩ or higher |
1 (SDN) - 3 (ECC1) |
"-" (Down shift) shift paddle switch operated and held |
Below 1 Ω |
"-" (Down shift) shift paddle switch not operated |
1 MΩ or higher |
If the result is not as specified, replace the shift paddle switch LH (transmission shift switch assembly). |
 |
*a |
Component without harness connected
(Shift Paddle Switch LH (Transmission Shift Switch Assembly)) |
|
|
(b) Shift Paddle Switch RH (Transmission Shift Switch Assembly):
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
1 (SUP) - 2 (ECC) |
"+" (Up shift) shift paddle switch operated and held |
Below 1 Ω |
"+" (Up shift) shift paddle switch not operated |
1 MΩ or higher |
If the result is not as specified, replace the shift paddle switch RH (transmission shift switch assembly). |
 |
*a |
Component without harness connected
(Shift Paddle Switch RH (Transmission Shift Switch Assembly)) |
|
|
Was this page helpful?