Vehicle Exterior

Inspection

8steps
~48min
2/5difficulty
Done 0 of 8

INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

(a) Check the operation.

(1) Connect a positive (+) lead from the auxiliary battery to connector terminal N2-2 (B).

NOTICE:

Do not connect a positive (+) lead from the auxiliary battery to any terminal other than terminal N2-2 (B) to avoid damaging the pulse sensor inside the motor.

*a

Component without harness connected

(Power Window Regulator Motor Assembly LH)

*b

Motor Gear

*c

Clockwise

*d

Counterclockwise

(2) Connect a negative (-) lead from the auxiliary battery to connector terminals N2-1 (GND) and N2-7 (DOWN) or N2-10 (UP).

(3) Check that the motor gear rotates smoothly as follows:

OK:

Measurement Condition

Specified Condition

  1. Connect a positive (+) lead from the auxiliary battery to terminal N2-2 (B), connect a negative (-) lead from the auxiliary battery to terminal N2-1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals N2-2 (B) and N2-1 (GND) connected, connect a negative (-) lead from the auxiliary battery to terminal N2-10 (UP).

Motor gear rotates clockwise

  1. Connect a positive (+) lead from the auxiliary battery to terminal N2-2 (B), connect a negative (-) lead from the auxiliary battery to terminal N2-1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals N2-2 (B) and N2-1 (GND) connected, connect a negative (-) lead from the auxiliary battery to terminal N2-7 (DOWN).

Motor gear rotates counterclockwise

  • If the result is not as specified, replace the power window regulator motor assembly LH.

CAUTION:

Initialize the power window control system after installing the rear door window regulator assembly.

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

(a) Check the operation.

(1) Connect a positive (+) lead from the auxiliary battery to connector terminal M2-2 (B).

NOTICE:

Do not connect a positive (+) lead from the auxiliary battery to any terminal other than terminal M2-2 (B) to avoid damaging the pulse sensor inside the motor.

*a

Component without harness connected

(Power Window Regulator Motor Assembly RH)

*b

Motor Gear

*c

Clockwise

*d

Counterclockwise

(2) Connect a negative (-) lead from the auxiliary battery to connector terminals M2-1 (GND) and M2-7 (DOWN) or M2-10 (UP).

(3) Check that the motor gear rotates smoothly as follows:

OK:

Measurement Condition

Specified Condition

  1. Connect a positive (+) lead from the auxiliary battery to terminal M2-2 (B), connect a negative (-) lead from the auxiliary battery to terminal M2-1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals M2-2 (B) and M2-1 (GND) connected, connect a negative (-) lead from the auxiliary battery to terminal M2-10 (UP).

Motor gear rotates counterclockwise

  1. Connect a positive (+) lead from the auxiliary battery to terminal M2-2 (B), connect a negative (-) lead from the auxiliary battery to terminal M2-1 (GND), and keep them connected for 3 seconds or more.
  2. With terminals M2-2 (B) and M2-1 (GND) connected, connect a negative (-) lead from the auxiliary battery to terminal M2-7 (DOWN).

Motor gear rotates clockwise

  • If the result is not as specified, replace the power window regulator motor assembly RH.

CAUTION:

Initialize the power window control system after installing the rear door window regulator assembly.