Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
KNOCK CONTROL SENSOR |
89615 |
- |
- |
|
2 |
INTAKE MANIFOLD |
17111 |
- |
- |
- |
3 |
PERFORM INITIALIZATION |
- |
- |
- |
|
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![]()
PROCEDURE
1. INSTALL KNOCK CONTROL SENSOR
![]() |
HINT: Perform "Inspection After Repair" after replacing the knock control sensor. Click here |
*a |
Top of Vehicle |
*b |
Right of Vehicle |
*c |
15° |
*d |
5° |
(1) Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
NOTICE:
- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
(2) Connect the knock control sensor connector.
2. INSTALL INTAKE MANIFOLD
Click here ![]()
3. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the knock control sensor.
Click here ![]()
.png)
.png)
.png)
.gif)