Installation
INSTALLATION
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
STARTER ASSEMBLY |
28100 |
- |
- |
- |
2 |
ENGINE WIRE |
82121 |
- |
- |
- |
3 |
FLYWHEEL HOUSING SIDE COVER |
11363A |
- |
- |
|
4 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
51410 |
- |
- |
- |
5 |
AIR CLEANER INLET NO. 1 |
17751 |
- |
- |
- |
6 |
NEGATIVE AUXILIARY BATTERY TERMINAL |
- |
- |
- |
- |
7 |
INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL |
- |
- |
- |
|
*1 |
COVER A |
*2 |
COVER B |
*3 |
STARTER TERMINAL |
*4 |
BASE |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
PROCEDURE
1. INSTALL STARTER ASSEMBLY
Torque:
for Bolt :
9,8 N·m {100 kgf·cm, 87 in·lbf}
for Nut :
46 N·m {469 kgf·cm, 34 ft·lbf}
2. INSTALL ENGINE WIRE
Torque:
for Bolt :
10 N·m {102 kgf·cm, 7 ft·lbf}
for Nut :
9,8 N·m {100 kgf·cm, 87 in·lbf}
3. INSTALL FLYWHEEL HOUSING SIDE COVER
(1) Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
NOTICE:
- Make sure the claw makes a click sound, indicating that it fits tightly.
- Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
4. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
5. INSTALL INLET NO. 1 AIR CLEANER INLET
Click here ![]()
6. CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click here ![]()
7. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function thatcompletes learning when the respective system is used.
Click here ![]()
.png)
.png)
.png)
.gif)
.png)
.png)