Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
16031 |
- |
- |
- |
2 |
ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) |
16032 |
- |
- |
- |
3 |
NO. 7 WATER BY-PASS HOSE |
- |
- |
- |
- |
4 |
NO. 2 RADIATOR HOSE |
16572D |
- |
- |
- |
5 |
INTAKE MANIFOLD |
17111 |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
6 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
51410 |
- |
- |
- |
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here ![]()
PROCEDURE
1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
(1) Install a new gasket to the engine water pump assembly (water inlet housing).
HINT:
Be sure to clean the contact surfaces.
(2) Install a new gasket to the water inlet with thermostat sub-assembly.
HINT:
Be sure to clean the contact surfaces.
(3) Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
(1) Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(2) Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(3) Connect the engine water pump assembly (water inlet housing) connector.
(4) Connect the sensor wire connector.
3. CONNECT NO. 7 WATER BY-PASS HOSE
*a |
15° |
*b |
90° |
*c |
Upper Side |
*d |
Front Side |
*e |
1 to 7 mm (0.0394 to 0.276 in.) |
- |
- |
(1) Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
4. CONNECT NO. 2 RADIATOR HOSE
Click here ![]()
5. INSTALL INTAKE MANIFOLD
Click here ![]()
6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
.png)
.png)
.png)
.png)