Engine & Hybrid System

Installation

~1min read
010203040502015N·mlb·ft
Tightening torque found on this page

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

KNOCK CONTROL SENSOR

89615

-

-

2

INTAKE MANIFOLD

17111

-

-

-

3

PERFORM INITIALIZATION

-

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click here

*a

Top of Vehicle

*b

Right of Vehicle

*c

15°

*d

5°

(1) Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

NOTICE:

  • If the knock control sensor has been struck or dropped, replace it.
  • Make sure that the knock control sensor is in the correct position.

(2) Connect the knock control sensor connector.

2. INSTALL INTAKE MANIFOLD

Click here

3. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing the knock control sensor.

Click here