Suspension

Installation

~2min read
03060901201509268N·mlb·ft
Tightening torque found on this page

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

48069

-

-

2

FRONT WHEEL

-

-

-

-

3

STABILIZE SUSPENSION

-

-

-

4

FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

48069

-

-

5

REAR ENGINE UNDER COVER LH

51444A

-

-

-

6

NO. 1 ENGINE UNDER COVER ASSEMBLY

51410

-

-

-

7

INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

-

-

-

8

PERFORM CALIBRATION

-

-

-

*A

w/ Parking Assist Monitor System

-

-

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf)

N*m (kgf*cm, ft.*lbf): Specified torque

PROCEDURE

1. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

(1) Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

(2) Install the front lower No. 1 suspension arm sub-assembly LH to the front lower ball joint assembly LH with the bolt and 2 nuts.

Torque:

92 N·m {938 kgf·cm, 68 ft·lbf}

2. INSTALL FRONT WHEEL

Click here

3. STABILIZE SUSPENSION

Click here

4. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

(1) Fully tighten the front lower No. 1 suspension arm sub-assembly with the 2 bolts.

Torque:

Bolt A :

240 N·m {2447 kgf·cm, 177 ft·lbf}

Bolt B :

135 N·m {1377 kgf·cm, 100 ft·lbf}

5. INSTALL REAR ENGINE UNDER COVER LH

6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here

7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Click here

8. PERFORM CALIBRATION (w/ Parking Assist Monitor System)

Parking assist monitor system

Automatic headlight beam level control system