Vehicle Exterior

Installation

~2min read

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

FRONT PILLAR UPPER COVER SUB-ASSEMBLY

60118

-

-

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT PILLAR UPPER COVER SUB-ASSEMBLY

NOTICE:

When installing the front pillar upper cover sub-assembly, heat the vehicle body using a heat light.

Standard:

Item

Temperature

Vehicle Body

40 to 60 °C

CAUTION:

  • Do not touch the heat light and heated parts.
  • Touching the heat light may result in burns.
  • Touching heated parts for a long time may result in burns.

*a

Heated Part

*b

Heat Light

NOTICE:

Do not heat the vehicle body excessively.

*a

Double-sided Tape

-

-

(1) Clean the vehicle body.

1. Using a heat light, heat the vehicle body surface.

2. Remove any remaining double-sided tape from the vehicle body.

3. Wipe off any tape adhesive residue with cleaner.

NOTICE:

  • Installing the front pillar upper cover sub-assembly with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
  • Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.

(2) Install the front pillar upper cover sub-assembly.

1. Using a heat light, heat the vehicle body.

2. Remove the release paper from the front pillar upper cover sub-assembly.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.

3. Engage the clips to install the front pillar upper cover sub-assembly.

HINT:

Press the front pillar upper cover sub-assembly firmly to install it.

(3) Remove the protective tape.