Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
75076 |
- |
- |
|
2 |
REAR DOOR OUTSIDE LOWER MOULDING SUB-ASSEMBLY |
75078 |
- |
- |
- |
3 |
HOLE PLUG |
- |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY
![]() |
NOTICE: When installing a new rear door outside moulding sub-assembly, heat the rear door panel using a heat light. |
Standard:
Item | Temperature |
|---|---|
Rear Door Panel |
40 to 60 °C |
CAUTION:
- Do not touch the heat light and heated parts.
- Touching the heat light may result in burns.
- Touching heated parts for a long time may result in burns.
*a |
Heated Part |
*b |
Heat Light |
NOTICE:
Do not heat the rear door panel excessively.
*a |
Double-sided Tape |
- |
- |
![]() |
Install in this Direction |
- |
- |
(1) Clean the rear door panel.
1. Using a heat light, heat the rear door panel surface.
2. Remove any remaining double-sided tape from the rear door panel.
3. Wipe off any tape adhesive residue with cleaner.
NOTICE:
- Installing the rear door outside moulding sub-assembly with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
- Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
(2) Install a new rear door outside moulding sub-assembly.
1. Using a heat light, heat the rear door panel surface.
2. Remove the release paper from the rear door outside moulding sub-assembly.
HINT:
After removing the release paper, keep the exposed adhesive free from foreign matter.
3. Engage the clips and claw to install the rear door outside moulding sub-assembly as shown in the illustration.
HINT:
Press the rear door outside moulding sub-assembly firmly to install it.
(3) Remove the protective tape.
(4) Install the screw.
2. INSTALL REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY
3. INSTALL HOLE PLUG
.png)
.png)
.png)
.gif)
.png)
.png)