Vehicle Exterior

Installation

~2min read
010203040502619N·mlb·ft
Tightening torque found on this page

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

ROOF RACK ASSEMBLY

63470B

-

-

2

ROOF HEADLINING ASSEMBLY

63310

-

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL ROOF RACK ASSEMBLY

NOTICE:

When installing the roof rack assembly, heat the vehicle body using a heat light.

Standard:

Item

Temperature

Vehicle Body

40 to 60 °C

CAUTION:

  • Do not touch the heat light and heated parts.

    *a

    Heated Part

    *b

    Heat Light

  • Touching the heat light may result in burns.
  • Touching heated parts for a long time may result in burns.

NOTICE:

Do not heat the vehicle body excessively.

*a

Double-sided Tape

-

-

(1) Install 3 new clips.

(2) Clean the vehicle body.

1. Using a heat light, heat the vehicle body.

2. Remove any remaining double-sided tape from the vehicle body.

3. Wipe off any tape adhesive residue with cleaner.

NOTICE:

  • Installing the roof rack assembly with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
  • Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.

(3) Install the roof rack assembly.

1. Using a heat light, heat the vehicle body.

2. Remove the release paper from the roof rack assembly.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.

3. Engage the clips to install the roof rack assembly.

HINT:

Press the roof rack assembly firmly to install it.

(4) Install the 4 nuts.

Torque:

26 N·m {265 kgf·cm, 19 ft·lbf}

(5) Remove the protective tape.

2. INSTALL ROOF HEADLINING ASSEMBLY

Click here