Engine & Hybrid System

On-vehicle Inspection

3steps
~18min
2/5difficulty
Done 0 of 3

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Click here

(a) Read the value of Data List item "MAF" using the GTS.

NOTICE:

Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

(1) Vehicle is made into the following state.

  1. Turn off all electrical loads, such as the air condition, etc.
  2. Check that the coolant temperature is 75 °C or more.
  3. Put the Shift Lever in the N position.

(2) Connect the GTS to the DLC3.

(3) Start the engine.

(4) Turn the GTS on.

(5) Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine > Data List

Mass Air Flow Sensor

(6) According to the display on the GTS, read the Data List when the engine is running.

Standard Condition:

GTS Display

Condition

Specified Condition

MAF

Idling (engine warmed up)

1.5 to 3.3 gm/sec

3000 rpm (without load)

8.0 to 13.0 gm/sec

If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly.

Click here

2. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Click here