Vehicle Exterior
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the A53 stop light switch assembly connector.
(b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
A53-7 (B) - A53-2 (GND) |
Always |
11 to 14 V |
A53-6 (B) - A53-2 (GND) |
Ignition switch on (IG) |
11 to 14 V |
Standard Resistance:
Tester Connection | Condition | Specified Condition |
A53-2 (GND) - Body ground |
Always |
Below 1 Ω |
If the result is not as specified, repair or replace the wire harness or connector. |
 |
*a |
Front view of wire harness connector
(to Stop Light Switch Assembly) |
|
|
(c) Connect the A53 stop light switch assembly connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
A53-1 (OUT) - A53-2 (GND) |
Brake pedal not depressed |
Below 1 V |
A53-1 (OUT) - A53-2 (GND) |
Brake pedal depressed |
11 to 14 V |
A53-3 (L) - A53-2 (GND) |
Brake pedal not depressed |
Below 1 V |
A53-3 (L) - A53-2 (GND) |
Brake pedal depressed |
11 to 14 V |
A53-4 (ACC) - A53-2 (GND) |
Always |
11 to 14 V |
A53-5 (L) - A53-2 (GND) |
Ignition switch on (IG), brake pedal not depressed |
11 to 14 V |
A53-5 (L) - A53-2 (GND) |
Ignition switch on (IG), brake pedal depressed |
Below 1 V |
If the result is not as specified, replace the stop light switch assembly. |
 |
*a |
Component with harness connected
(Stop Light Switch Assembly) |
|
|
Was this page helpful?