Vehicle Interior

Problem Symptoms Table

~2min read

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to the system before inspecting the suspected areas below.
  • If the problem occurs in certain locations or times of day, the possibility of wave interference is high.
  • If a malfunction occurred after optional components were installed by the dealer, check if there is wave interference from the components.
Smart Key System (for Start Function)

Symptom

Suspected Area

Link

Power source mode does not change to ON or ACC

Smart key system (for Entry Function)

Affected by wave interference

Transmitter battery

Electrical key transmitter sub-assembly

No. 1 indoor electrical key antenna assembly (front floor)

No. 3 indoor electrical key antenna assembly (inside luggage compartment)

Engine switch

Wire harness or connector

Power distribution box assembly

Certification ECU (Smart key ECU assembly)

Power source mode does not change to ON

Wire harness or connector

Relay

Power distribution box assembly

Certification ECU (Smart key ECU assembly)

Power source mode does not change to ACC

Wire harness or connector

Relay

Power distribution box assembly

Certification ECU (Smart key ECU assembly)

Only +BA power source mode does not operate correctly

Smart key system (for Entry Function)

Wireless door lock control system

Power door lock control system

Power distribution box assembly

New key cannot be registered

LIN communication system

Meter / gauge system

Reregistration

Electrical key transmitter sub-assembly

ID code box (Immobiliser code ECU)

Certification ECU (Smart key ECU assembly)

Additional key cannot be registered

Smart key system (for Start Function)

Steering lock function

Electrical key transmitter sub-assembly

ID code box (Immobiliser code ECU)

Certification ECU (Smart key ECU assembly)

New key registration warning message is not displayed

Lighting system (int)

Meter / gauge system

Certification ECU (Smart key ECU assembly)

Security indicator light does not blink

Wire harness or connector

Security indicator light

Main body ECU (Multiplex network body ECU)

Certification ECU (Smart key ECU assembly)

Immobiliser system does not operate properly

Communication ID registration was defective

Wire harness or connector

ID code box (Immobiliser code ECU)

ECM

System malfunction message is displayed on the multi-information display

Smart key system (for Entry Function)

Smart key system (for Start Function)

Certification ECU (Smart key ECU assembly)

Electronically controlled brake system