Reassembly
REASSEMBLY
COMPONENTS (REASSEMBLY)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
63205A |
- |
- |
|
2 |
REAR NO. 1 SLIDING ROOF SUNSHADE STOPPER |
- |
- |
- |
- |
3 |
REAR ROOF DRIP CHANNEL |
- |
- |
- |
|
4 |
SUNSHADE TRIM SUB-ASSEMBLY |
63306 |
- |
- |
- |
5 |
SLIDING ROOF PIECE SUB-ASSEMBLY |
- |
- |
- |
- |
6 |
SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
63260A |
- |
- |
|
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
![]() |
MP grease |
PROCEDURE
1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY
![]() |
NOTICE: Perform this procedure only when replacement of the sliding roof drive cable sub-assembly is necessary. |
*a |
Alignment Mark |
- |
- |
● |
Non-reusable part |
![]() |
Hold Down |
![]() |
Push Position |
![]() |
Install in this Direction |
(1) Hold down the roof wind deflector panel sub-assembly.
(2) Using a screwdriver with its tip wrapped with protective tapes, install the sliding roof drive cable sub-assembly as shown in the illustration.
HINT:
Use the same procedure for the opposite side.
(3) Adjust Fully Closed Position:
1. Using a screwdriver with its tip wrapped with protective tapes, align the alignment marks as shown in the illustration.
HINT:
Use the same procedure for the opposite side.
2. INSTALL REAR NO. 1 SLIDING ROOF SUNSHADE STOPPER
3. INSTALL REAR ROOF DRIP CHANNEL
![]() |
NOTICE: Perform this procedure only when replacement of the sliding roof drive cable sub-assembly is necessary. |
4. INSTALL SUNSHADE TRIM SUB-ASSEMBLY
5. INSTALL SLIDING ROOF PIECE SUB-ASSEMBLY
6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
![]() |
MP grease |
- |
- |
(1) Apply MP grease to the gear of the sliding roof drive gear sub-assembly.
(2) Install the sliding roof drive gear sub-assembly with the 2 bolts.
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
.png)
.png)
.png)
.gif)
.png)
.png)
.png)
.png)
.png)