Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
51410 |
- |
- |
- |
2 |
REAR ENGINE UNDER COVER LH |
51444A |
- |
- |
- |
3 |
DRAIN ENGINE COOLANT |
- |
- |
- |
|
4 |
DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID |
- |
- |
- |
|
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
5 |
INLET WATER HOSE |
16262 |
- |
- |
- |
6 |
NO. 2 WATER BY-PASS HOSE |
16264D |
- |
- |
- |
7 |
TRANSMISSION OIL COOLER |
33493C |
- |
- |
- |
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transmission oil cooler removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/ReplacedReplacement Part or Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
CVT fluid |
ATF thermal degradation estimate reset |
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly |
|
Bleed air from oil pump (continuously variable transaxle assembly) |
Stop and start system |
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
![]()
2. REMOVE REAR ENGINE UNDER COVER LH
Click here
![]()
3. DRAIN ENGINE COOLANT
Click here ![]()
4. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Click here ![]()
5. DISCONNECT INLET WATER HOSE
6. DISCONNECT NO. 2 WATER BY-PASS HOSE
7. REMOVE TRANSMISSION OIL COOLER
.png)
.png)
.png)
.png)
.gif)