Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
- |
- |
- |
- |
2 |
DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
32101B |
- |
- |
|
3 |
NO. 1 CRANKSHAFT POSITION SENSOR PLATE |
19315 |
- |
- |
- |
4 |
REAR ENGINE OIL SEAL |
11401L |
- |
- |
|
*1 |
REAR DRIVE PLATE SPACER |
- |
- |
● |
Non-reusable part |
![]() |
MP grease |
![]() |
Adhesive 1324 |
★ |
Precoated part |
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.
HINT:
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven.
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front camera system
Drive the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
- for 2WD
Click here
.gif)
- for 4WD
Click here
.gif)
2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
(1) Using SST, hold the crankshaft pulley assembly.
SST: 09213-54015
SST: 09330-00021
(2) Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly.
3. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
4. REMOVE REAR ENGINE OIL SEAL
*a |
Cut Position |
- |
- |
(1) Using a knife, cut off the lip of the rear engine oil seal.
(2) Using a screwdriver, pry out the rear engine oil seal.
NOTICE:
Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.
HINT:
Tape the screwdriver tip before use.
.png)
.png)
.png)
.png)
.png)