Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
TAIL EXHAUST PIPE ASSEMBLY |
17430 |
- |
- |
|
2 |
FRONT FLOOR CENTER BRACE |
57533B |
- |
- |
- |
3 |
NO. 2 AIR FUEL RATIO SENSOR |
89467B |
- |
- |
- |
4 |
FRONT EXHAUST PIPE ASSEMBLY |
17410 |
- |
- |
|
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
Gas leak from exhaust system is repaired |
Inspection after repair |
|
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
PROCEDURE
1. REMOVE TAIL EXHAUST PIPE ASSEMBLY
![]() |
CAUTION: To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot. |
2. REMOVE FRONT FLOOR CENTER BRACE
Click here ![]()
3. REMOVE NO. 2 AIR FUEL RATIO SENSOR
Click here ![]()
4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
![]() |
Click here |
.png)
.png)
.png)
.gif)