Vehicle Exterior

Removal

~1min read

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

FRONT FENDER MOULDING SUB-ASSEMBLY

75602A

-

-

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

(1) Remove the screw.

(2) Remove the 5 clips and 2 grommets.

Push

Place Hand Here

Remove in this Direction (1)

Remove in this Direction (2)

(1) Apply protective tape around the front fender moulding sub-assembly as shown in the illustration.

(2) Pull back the edge of the front fender liner and disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:

  • Do not apply excessive force when pulling back the front fender liner.
  • To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly.

(3) Disengage the clips to remove the front fender moulding sub-assembly as shown in the illustration.