Transmission Wire
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
TRANSMISSION VALVE BODY ASSEMBLY |
35410J |
- |
- |
- |
2 |
TRANSMISSION WIRE |
82125M |
- |
- |
|
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transmission wire removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/ReplacedReplacement Part or Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
CVT fluid |
ATF thermal degradation estimate reset |
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly |
|
Bleed air from oil pump (continuously variable transaxle assembly) |
Stop and start system |
PROCEDURE
1. REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Click here ![]()
2. REMOVE TRANSMISSION WIRE
(1) Disengage the claw, rotate the lever and disconnect the connector.
(2) Disconnect the connector.
(3) Remove the bolt and transmission wire from the transaxle case sub-assembly.
(4) Remove the O-ring from the temperature sensor.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
TRANSMISSION WIRE |
82125M |
- |
- |
|
2 |
TRANSMISSION VALVE BODY ASSEMBLY |
35410J |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
![]() |
Toyota Genuine CVT Fluid FE |
- |
- |
PROCEDURE
1. INSTALL TRANSMISSION WIRE
![]() |
Toyota Genuine CVT Fluid FE |
- |
- |
(1) Coat the O-ring of the transmission wire with Toyota Genuine CVT fluid FE.
NOTICE:
If reusing the transmission wire, check that the O-ring is not damaged.
(2) Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the temperature sensor.
NOTICE:
Ensure that the O-ring is not twisted.
(3) Install the transmission wire to the transaxle case sub-assembly with the bolt.
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
(4) Connect the connector.
(5) Connect the connector and rotate the lever and engage the claw.
NOTICE:
Rotate the lever until the claw of the connector makes a click sound.
2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Click here ![]()
.png)
.png)
.png)
.gif)
.png)
.png)
.png)
.gif)
.png)
.png)