Toyota Corolla Quiz
Diagnostics

Inspection procedure

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
10steps
~60min
3/5difficulty
Done 0 of 10
1 Inspect cruise control actuator assy
Toyota Corolla. Inspect cruise control actuator assy
  1. Inspect the cruise control actuator arm locking operation.
  2. Turn the ignition switch to off.
  3. Disconnect the cruise control actuator assy connector.
  4. Connect the positive (+) lead from the battery to the terminal 3 (l) of cruise control actuator assy and the negative (–) lead to terminal 4 (gnd).
    Toyota Corolla. Inspect cruise control actuator assy
Notice

: do not connect the high tension cables to the wrong battery terminal. You will damage the cruise control actuator assy.
  1. Move the control plate by hand.

    Ok: control plate does not move.

  2. inspect the cruise control actuator assy operation.
  3. Turn the ignition switch to off.
  4. Disconnect the cruise control actuator assy connector.
  5. Connect the positive (+) lead from the battery to terminals 1 (mo) and 3 (l) of cruise control actuator assy, connect the negative (–) lead to terminals 2 (mc) and 4 (gnd) of cruise control actuator assy.

    Ok: control arm moves to full open side.

  6. Connect the positive (+) lead from the battery to terminals 2 (mc) and 3 (l) of cruise control actuator assy, connect the negative (–) lead to terminals 1 (mo) and 4 (gnd) of cruise control actuator assy.

    Ok: control arm moves to full close side.

    Toyota Corolla. Inspect cruise control actuator assy
    2 Check harness and connector(between cruise control ecu assy
2 Check harness and connector(between cruise control ecu assy and cruise control actuator assy)
  1. Check for open and short circuit in harness and connector between cruise control ecu assy and cruise control actuator assy (actuator motor)
Check and replace cruise control ecu assy
Check and replace cruise control ecu assy

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.