Oxygen / af sensor heater monitor

1. Preconditions

The monitor will not run unless:

• mil is off

1. 1
   drive pattern
2. 2
   connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.
3. 3
   Start the engine and allow it to idle for 9 minutes.
4. 4
   Drive the vehicle at 40 km/h or more for at least 2 minutes.
5. 5
   If the readiness status dose not switch to complete, make sure that the preconditions are met and the ignition switch turned off and then repeat steps (2) and (3).