Toyota Corolla Quiz
Diagnostics

Evap monitor (vacuum pressure monitor)

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
~1min read
Notice

: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor.
  1. Cold soak preconditions

The monitor will not run unless:

  • mil is off.
  • Fuel level is approximately 1/2 to 3/4.
  • Altitude is 7800 feet (2400 m) or less.
  1. cold soak procedure

Let the vehicle cold soak for 8 hours or until the difference between iat and ect becomes less than 13°f (7 °C).

Hint

: examples:
  • scenario 1
    ect = 75°f (24 °C)
    iat = 60°f (16 °C)
    difference between ect and iat is 15°f (8 °C).

    The monitor will not run because difference between ect and iat is greater than 13°f (7 °C).

  • Scenario 2
    ect = 70°f (21 °C)
    iat = 68°f (20 °C)
    difference between ect and iat is 2°f (1 °C).

    The monitor will run because difference between ect and iat is less than 13°f (7 °C).

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.