Toyota Corolla Quiz
Exterior/interior trim

Rear door belt moulding assy lh

In this manual: Exterior/interior trim
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
2steps
~12min
1/5difficulty
Done 0 of 2
Replacement Hint

:
  • the installation procedures are the removal procedures in reverse order.
  • Use the same procedures for the rh side and lh side.
1. Remove rear armrest assy lh 2. Remove power window regulator switch assy rear (w/ power window) 3. Remove rear door window regulator handle assy (w/o power window) 4. Remove rear door trim board sub–assy lh 5. Remove rear door belt moulding assy lh
Toyota Corolla. Remove rear door belt moulding assy lh
  1. Put protective tape under the weatherstrip.
  2. using a moulding remover, pry out the weatherstrip as shown in the illustration.
Hint

: tape the moulding remover tip before use.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.