Out side moulding

1. 1
   Put protective tape around the moulding.
2. 2
   insert a piano wire between the vehicle body and moulding.
3. 3
   tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
4. 4
   pull the piano wire and scrape off the double–sided tape that holds the moulding to the vehicle body.

• if reusing the moulding, take care not to damage the moulding.
• Becareful not to damage the body.

5. remove the moulding.

1. using a heat light, heat the body.

   Heating temperature: 40 to 60 c (104 to 140 f)

1. 1
   remove the double–sided tape from the body.
2. 2
   wipe off the stains with cleaner.
3. 3
   clean the moulding (if reusing).
4. 4
   Using a heat light, heat the body. Heating temperature: 20 to 30 c (68 to 86 f). Notice

   : do not heat the moulding excessively.

5. 5
   Remove the double–sided tape from the moulding.
6. 6
   Wipe off the stains with cleaner.
7. 7
   Apply new adhesive tape to the moulding as shown in the illustration.

   

8. 8
   Using a heat light, heat the body and moulding.

Heating temperature:

1. 1
   remove the peeling paper from the double–sided tape on the moulding face. Notice

   : when the peeling paper is removed, take care that no dirt or dust contaminates the adhesive.

2. 2
   affix the moulding to the body, as shown in the illustration. Notice

   : do not apply excessive force onto the moulding. Use steady pressure with your thumbs.