Toyota Corolla Quiz
Cooling

Replacement

In this manual: Cooling
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
6steps
~36min
2/5difficulty
Done 0 of 6
1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt
Toyota Corolla. Remove fan and generator v belt
4. Remove generator assy
Toyota Corolla. Remove generator assy
  1. Disconnect the wire clamp from the wire clip on the rectifire end frame.
  2. remove the rubber cap and nut, and disconnect the alternator wire.
  3. disconnect the alternator connector.
    Toyota Corolla. Remove generator assy
  4. Remove the 2 bolts and alternator.
5. Remove water pump assy
Toyota Corolla. Remove water pump assy
  1. Remove the 6 bolts, water pump and o–ring.
6. Install water pump assy
Toyota Corolla. Install water pump assy
  1. Place a new o–ring on the timing chain cover.
  2. install the water pump with the 6 bolts.

    Torque:
    bolt a 9.0 Nvm (92 Kgf·cm, 80 invlbf) bolt b 11 nvm (113 Kgf·cm, 8 ft·lbf)

7. Install generator assy

Torque:
12 mm head 25 nvm (250 Kgf·cm, 18 ft·lbf) 14 mm head 54 nvm (550 Kgf·cm, 39 ft·lbf)

8. Add coolant 9. Check engine coolant leak

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.