Toyota Corolla Quiz
Brake

Skid control sensor

In this manual: Brake
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
~2min read
Replacement Hint

: replace the rh side by the same procedure as the lh side.

 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire
Toyota Corolla. Disconnect skid control sensor wire
  1. Disconnect the skid control sensor wire connector from the skid control sensor.
4. Remove rear axle hub & bearing assy lh 5. Remove skid control sensor
Toyota Corolla. Remove skid control sensor
  1. Mount the rear axle hub in a soft jaw vise.
Notice

: replace the axle hub assembly if it is dropped or a strong shock is given to it.
  • using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from sst.
  • using sst and 2 bolts (diameter: 12 mm, pitch: 1.5 Mm), remove the skid control sensor from the rear axle hub.

    Sst 09520–00031 (09520–00040), 09521–00020, 09950–00020

    • Notice

    :
    • if a damage is inflicted to the sensor rotor, replace the axle hub assembly.
    • Do not scratch the contacting surface of axle hub and speed sensor.
    6. Install skid control sensor
    Toyota Corolla. Install skid control sensor
    1. clean the contacting surface of the axle hub and a new speed sensor.
    Notice

    : do not stick any foreign objects to the sensor rotor.
  • place the speed sensor on the axle hub so that the connector makes the lowest position under the on–vehicle condition.
    • Toyota Corolla. Install skid control sensor
    1. Using sst and press, install the new speed sensor to the axle hub.

      Sst 09214–76011

    7. Install rear axle hub & bearing assy lh 8. Connect skid control sensor wire
    Toyota Corolla. Connect skid control sensor wire
    1. Connect the skid control sensor wire connector to the skid control sensor.
    9. Install rear brake drum sub–assy 10. Install rear wheel

    torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

    11. Inspect and adjust rear wheel alignment 12. Check abs speed sensor signal

    Test yourself

    A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.