Toyota Corolla Quiz
Brake

Speed sensor front lh

In this manual: Brake
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
7steps
~42min
2/5difficulty
Done 0 of 7
Replacement Hint

: replace the rh side by the same procedure as the lh side.

 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh
Toyota Corolla. Remove speed sensor front lh
  1. Disconnect the speed sensor wire harness clamp from the body.
  2. disconnect the speed sensor connector.
    Toyota Corolla. Remove speed sensor front lh
  3. Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
    Toyota Corolla. Remove speed sensor front lh
  4. Remove the bolt and speed sensor front lh.
Notice

: keep on the sensor tip clean.

 4. Install speed sensor front lh
Toyota Corolla. Install speed sensor front lh
  1. Install the speed sensor front lh with the bolt.

    Torque: 8.0 Nvm (82 Kgf·cm, 71 in.Vlbf)

Notice

: make sure the sensor tip is clean.
Toyota Corolla. Install speed sensor front lh
  1. Install the sensor harness clamp with the 2 bolts ”a” and ”b” to the body and shock absorber.

    Torque:
    bolt a: 8.0 Nvm (82 Kgf·cm, 71 in.Vlbf) bolt b: 29 nvm (296 Kgf·cm, 21 ft·lbf)

    Toyota Corolla. Install speed sensor front lh
  2. Connect the speed sensor connector.
  3. connect the speed sensor wire harness clamp to the body.
5. Install front fender liner lh 6. Install front wheel

torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

7. Check abs speed sensor signal

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.