Heater & air conditioner

Inspection

~1min read

1. INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

 INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

 INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

(a) Belt tension: Using a belt tension gauge, check the V belt tension

 INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

NOTICE:

  • Check the V belt deflection at the specified point.
  • When installing a new belt, set its tension value as specified.
  • When checking a belt used for over 5 minutes, confirm the deflection value is within the specified range.
  • When reinstalling a belt used for over 5 minutes, perform the check based on the used deflection value.
  • V belt tension and deflection values should be checked after 2 revolutions of engine cranking.
  • When using a belt tension gauge, confirm the accuracy first by using a master gauge.
  • Check that the drive belt fits properly in the ribbed grooves.
 INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1