Wiper & washer
Inspection
In this manual: Wiper & washer
13steps
~78min
3/5difficulty
Done 0 of 13
1. WINDSHIELD WIPER SWITCH ASSY

(a) Continuity Check
- Measure the resistance according to the value(s) in the table below.
Standard:
Front Wiper Switch

Front Washer Switch

Rear Wiper and Washer Switch

(b) Intermittent Operation Check
- Connect the voltmeter (+) terminal to terminal 7 (+1) of the connector, the voltmeter (-) terminals to terminal 2 (EW) of the connector.
- Connect the battery (+) to terminal 17 (+B) of the connector, the battery (-) to terminal 2 (EW) and 16 (+S) of the connector.
- Turn the wiper switch to INT.
- Connect the battery (+) to terminal 16 (+S) of the connector for 5 seconds.
- Connect the battery (-) to terminal 16 (+S) of the connector. Operate the intermittent wiper relay and check voltage between terminal 7 (+1) and terminal 2 (EW).


(c) Operation Check (Front Wiper)
- Turn the wiper switch OFF.
- Connect the positive (+) lead from the battery to terminal 17 (+B) and the negative (-) lead to terminals 2 (EW) and 16 (+S).
- Connect the positive (+) lead from the voltmeter to terminal 7 (+1) and the negative (-) lead to terminal 2 (EW).Turn the washer switch ON and OFF and check voltage between terminal 7 (+1) and terminal 2 (EW).
2. WINDSHIELD WIPER MOTOR ASSY

(a) LO Operation Check
- Connect the positive (+) lead from the battery to terminal 1 (+1) and the negative (-) lead to terminal 5 (E), check that the motor operates at low speed.
(b) HI Operation Check
- Connect the positive (+) lead from the battery to terminal 4 (+2) and the negative (-) lead to terminal 5 (E), and check that the motor operates at high speed.

(c) Automatic Stop Operation Check
- Connect the positive (+) lead from the battery to terminal 1 (+1) and the negative (-) lead to terminal 5 (E), and operate the motor at low speed and stop the motor operation anywhere except at the stop position by disconnecting positive (+) lead from terminal 1 (+1).
- Connect terminals 1 (+1) and 3 (S).
- Connect the positive (+) lead from the battery to terminal 2 (B), and check that the motor stops running at the stop position after the motor operates again.
3. REAR WIPER MOTOR ASSY

(a) Operation Check
- Connect the positive (+) lead from the battery to terminal 1 (+B) and the negative (-) lead to terminal 3 (LS), and check that the motor operates.
NOTICE: The body earth should be connected.

(b) Automatic Stop Position Operation Check
- Connect the positive (+) lead from the battery to terminal 1 (+B) and the negative (-) lead to terminal 3 (LS).
NOTICE: The body earth should be connected.
- With the motor being rotated, disconnect terminal 1 (+B) and terminal 3 (LS) to stop the motor operation at any position except the automatic stop position.
- Connect the positive (+) lead from the battery to terminal 1 (+B), and check that the motor is restarted and automatically stopped.
NOTICE: The body earth should be connected.
Was this page helpful?