Warning message and warning buzzer list
| Warning message | Details/actions |
![]() | Indicates that:
Slow the vehicle by applying the brakes. |
![]() | Indicates that the engine was stopped with the shift lever not in p a buzzer also sounds. → Shift the shift lever to p. |
![]() | Indicates that the engine was stopped while driving a buzzer also sounds. → Stop the vehicle in a safe place such as the shoulder of a road. |
![]() | Indicates that your vehicle is nearing the vehicle ahead (in vehicle-to-vehicle distance mode) a buzzer also sounds. → Slow the vehicle by applying the brakes. |
![]()
![]() | Alerts the driver that the vehicle has deviated from the lane (while the lda [lane departure alert] system is operating) the lane line on the side the vehicle has deviated from flashes. |
Monochrome display

Color display

sounds to indicate that the door(s) are not yet fully closed. → Make sure that all the doors are closed.
Monochrome display

Color display

sounds to indicate that the hood is not yet fully closed.
→ Close the hood.
Monochrome display

Color display

sounds to indicate that the back door is not yet fully closed.
→ Close the back door.
Monochrome display

Color display

sounds to indicate that the glass hatch is not yet fully closed.
→ Close the glass hatch.
Monochrome display

Color display

Monochrome display

Color display

→ Clean the sensor.

→ Have the vehicle inspected by your toyota dealer.

→ Release the parking brake.
Color display only

Color display only

→ Immediately stop the vehicle in a safe place and contact your toyota dealer. Continuing to drive the vehicle may be dangerous.
Color display only

→ Clean the sensor.
Color display only

→ Turn off snow mode.
If the windshield wipers are on, turn them off or set them to a mode other than high speed wiper operation.

→ Restart the lda after driving for a while.

→ Clean the sensor and its surrounding area on the bumper.

- the cruise control system; or
- the dynamic radar cruise control system press the "on-off" button once to deactivate the system, and then press the button again to reactivate the system.
→ Have the vehicle inspected by your toyota dealer.

→ Have the vehicle inspected by your toyota dealer
Color display only

→ Have the vehicle inspected by your toyota dealer.

→ Have the vehicle inspected by your toyota dealer.
Color display only

→ Immediately stop the vehicle in a safe place and contact your toyota dealer.

→ Have the vehicle inspected by your toyota dealer.

→ Have the vehicle inspected by your toyota dealer.


→ Operate the steering wheel with more force than usual.

→ Turn the lights off.

→ Close the moon roof or panoramic moon roof.

→ Reduce vehicle speed or stop the vehicle in a safe place until the warnings clear. In this case, do not stop the engine.

Monochrome display

Color display

→ Have the vehicle inspected by your toyota dealer.

→ Have the vehicle inspected by your toyota dealer.
Monochrome display

Color display



→ If necessary, perform maintenance.

Comes on approximately 5000 miles (8000 km) after the maintenance data has been reset.
(The indicator will not work properly unless the maintenance data has been reset.) → Perform the necessary maintenance.
Please reset the maintenance data after the maintenance is performed
→ Turn the high beam on and press the automatic high beam switch again.
Color display only

Color display only

*: Refer to the separate “scheduled maintenance guide” or “owner’s manual supplement” for the maintenance interval applicable to your vehicle.
Messages displaysThe message illustrations used are intended as examples, and may differ from the image that is actually displayed on the multi-information display.
Warning message in dynamic radar cruise control mode (if equipped)In the following situations, the warning message may not be displayed even if vehicle-to-vehicle distance decreases:
- when your vehicle and the vehicle ahead are traveling at the same speed or the vehicle ahead is traveling more quickly than your vehicle
- when the vehicle ahead is traveling at a very low speed
- immediately after cruise control speed is set
- at the instant the accelerator pedal is depressed
In the following situations, a warning message will not be displayed even if a lane line is crossed.
- When the vehicle speed deviates from the operating range of the lda system functions
- When the lane lines cannot be recognized





