Components (2005/11-2006/01)

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ecu power source circuit.

1. 1
   Perform active test by intelligent tester (sliding roof operation)
2. 2
   Select the active test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.

Sliding roof ecu

1. 1
   Inspect fuse (s/roof, ecu-ig1)
2. 2
   Remove the s/roof and ecu-ig1 fuses from the instrument panel junction block.
3. 3
   Measure the resistance of the fuses.

Standard resistance: below 1

3. Check wire harness (sliding roof drive gear - body ground)

1. 1
   Disconnect the p6 drive gear connector.
2. 2
   Measure the voltage and resistance of the wire harness side connector.

Standard voltage

Standard resistance