Toyota RAV4 Quiz
Seat

Installation

In this manual: Seat
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
21steps
~126min
4/5difficulty
Done 0 of 21
Hint:
  • Use the same procedures for the rh side and lh side.
  • The procedures listed below are for the rh side.
  1. Install front seat assembly
  2. Place the seat in the cabin.
Notice:

Be careful not to damage the vehicle body.

Toyota RAV4. Install front seat assembly

  1. Connect the connector under the seat.
  2. Lift up the seat track adjusting handle and move the seat to the rearmost position.
  3. Tighten the 2 bolts on the front side of the seat.
Torque: 37 n*m (377 kgf*cm, 27 ft.*Lbf) Hint:

Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.
Toyota RAV4. Install front seat assembly

  1. Tighten the 2 bolts on the rear side of the seat.
Torque: 37 n*m (377 kgf*cm, 27 ft.*Lbf) Hint:

Tighten the bolts in the order indicated in the illustration.

  1. Inspect and adjust seat slide adjuster locks
  2. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
  3. Install front seat track bracket outer cover lh
    Toyota RAV4. Install front seat track bracket outer cover lh
If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.
  1. Install the outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
  2. Install front seat track bracket inner cover lh
    Toyota RAV4. Install front seat track bracket inner cover lh

  1. Install the inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
  2. Install front seat headrest assembly
  3. Connect cable to negative battery terminal
  4. Check srs warning light (w/ front seat side airbag)
  5. Check the srs warning light (see page rs-37).
  6. Inspect front seat assembly
  7. For passenger side: perform the zero point calibration and sensitivity check (see page rs-241).
  8. W/ seat heater system: check the seat heater operation.
  9. Turn the ignition switch on (ig).
  10. Push the seat heater switch on.
  11. Wait 5 minutes or more and confirm that the seat surface becomes warm.

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.