Toyota RAV4 Quiz
Supplemental restraint system

Installation

In this manual: Supplemental restraint system
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
11steps
~66min
3/5difficulty
Done 0 of 11
Caution: Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
  1. Install steering pad assembly
Toyota RAV4. Install steering pad assembly

  1. Support the steering pad with one hand as shown in the illustration.
  2. Connect the 2 airbag connectors.
Notice:

When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.
  2. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
  3. Using a t30 "torx" driver, install the 2 screws.
    Toyota RAV4. Install steering pad assembly
Torque: 8.8 N*m (90 kgf*cm, 78 in.*Lbf)
  1. Connect cable to negative battery terminal
  2. Inspect steering pad assembly
  3. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
  4. Check that the horn sounds.
  5. Check srs warning light
  6. Check the srs warning light (see page rs-34).

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.