Parking brake lever

Components

On-vehicle inspection

1. Check parking brake switch assembly

1. Remove the rear console box (see page ip-16).

Hint:

Refer to the procedures from the removal of the no.

1 Console upper panel garnish up until the removal of the rear console box sub-assembly.

1. 1
   Disconnect the parking brake switch connector.
2. 2
   Measure the resistance of the switch.

Standard resistance

If the result is not as specified, replace the switch assembly.

Removal

1. Disconnect cable from negative battery terminal

Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

1. 1
   Remove rear console box sub-assembly
2. 2
   Remove the rear console box (see page ip-16).

Hint:

Refer to the procedures from the removal of the no.

1 Console upper panel garnish up until the removal of the rear console box sub-assembly.

1. 1
   Remove parking brake lever sub-assembly
2. 2
   Disconnect the parking brake switch connector.
3. 3
   Remove the lock nut and wire adjusting nut.

   

3. Disconnect the no. 1 Parking brake cable from the parking brake equalizer.

1. 1
   Remove the 2 bolts and parking brake lever (with the no. 1 Parking brake cable).
2. 2
   Remove no. 1 Parking brake cable assembly

   

1. 1
   Disconnect the cable from the lever.
2. 2
   Remove parking brake switch assembly
3. 3
   Remove the screw and switch from the lever.

Installation

1. 1
   Install parking brake switch assembly
2. 2
   Install the parking brake switch with the screw.
3. 3
   Install no. 1 Parking brake cable assembly
4. 4
   Connect the cable to the lever.
5. 5
   Install parking brake lever sub-assembly

   

Torque: 0.88 N*m (9.0 Kgf*cm, 7.8 In.*Lbf)

1. Install the parking brake lever (with the no. 1 Parking brake cable) with the 2 bolts.

Torque: 14.5 N*m (148 kgf*cm, 11 ft.*Lbf)

2. Connect the no. 1 Parking brake cable to the parking brake equalizer.

1. 1
   Temporarily install the wire adjusting nut and lock nut.
2. 2
   Connect the parking brake switch connector.
3. 3
   Check parking brake lever travel (see page pb-1)
4. 4
   Adjust parking brake lever travel (see page pb-2)
5. 5
   Install rear console box sub-assembly
6. 6
   Install the rear console box (see page ip-23).

Hint:

Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the no. 1 Console upper panel garnish.

7. Connect cable to negative battery terminal