Parking brake cable

Components

Removal

1. 1
   Remove rear console box sub-assembly
2. 2
   Remove the rear console box (see page ip-16).

Hint:

Refer to the procedures from the removal of the no.

1 Console upper panel garnish up until the removal of the rear console box sub-assembly.

1. 1
   Loosen lock nut and no. 1 Wire adjusting nut (see page pb-1)
2. 2
   Remove parking brake equalizer

   

1. 1
   Disconnect the 3 cable ends and then remove the equalizer.
2. 2
   Remove rear wheel
3. 3
   Remove parking brake cable

   

1. 1
   Remove the cable clamp (labeled a) from the body.
2. 2
   Remove the casing cap bolt (labeled b) from the body.
3. 3
   Remove the clamp bolt (labeled c) from the body.
4. 4
   Remove the clamp bolt (labeled d) from the crossmember.
5. 5
   Remove the clamp bolt (labeled e) from the rear suspension crossmember.
6. 6
   Remove the clamp bolt (labeled f) from the trailing arm.
7. 7
   Disconnect the cable from the parking brake shoe lever and backing plate.
8. 8
   Disconnect the cable from the lever (see page pb-13).
9. 9
   Remove the bolt and disconnect the cable from the backing plate.

Installation

1. 1
   Install parking brake cable
2. 2
   Connect the cable to the backing plate and parking brake shoe lever.
3. 3
   Pass the cable through the backing plate, and then connect the cable to the lever.
4. 4
   Install the cable to the backing plate with the bolt.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*Lbf)

2. Install the clamp and clamp bolt (labeled f) to the trailing arm.

Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf) Notice:

Securely install the clamp.

3. Install the clamp and clamp bolt (labeled e) to the rear suspension crossmember.

Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf) Notice:

Securely install the clamp.

4. Install the clamp and clamp bolt (labeled d) to the crossmember.

Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf) Notice:

Securely install the clamp.

5. Install the clamp and clamp bolt (labeled c) to the body.

Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf) Notice:

Securely install the clamp.

6. Install the casing cap and casing cap bolt (labeled b) to the body.

Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf) Notice:

Securely install the casing cap.

7. Install the cable clamp (labeled a) to the body.

Notice:

Securely install the clamp.

2. Install parking brake equalizer

1. 1
   Connect the 3 cable ends to the equalizer.
2. 2
   Install rear wheel

Torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)

1. 1
   Adjust parking brake lever travel (see page pb-2)
2. 2
   Install rear console box sub-assembly
3. 3
   Install the rear console box (see page ip-23).

Hint:

Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the no. 1 Console upper panel garnish.