Toyota RAV4 Quiz
Other system

Rear power outlet socket

In this manual: Other system
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
33steps
~198min
4/5difficulty
Done 0 of 33
Components
Toyota RAV4. Rear power outlet socket

Toyota RAV4. Rear power outlet socket

Removal
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove rear door scuff plate lh (see page ir-26)
  2. Remove rear door opening trim weatherstrip lh
  3. Remove package tray trim pocket subassembly
  4. Remove tonneau cover assembly
  5. Remove rear floor no. 1 Board
  6. Remove deck board assembly
  7. Remove rear floor no. 3 Board
  8. Remove rear floor no. 2 Board
  9. Remove rear floor no. 1 Mat support side plate (see page ir-31)
  10. Remove back door weatherstrip
  11. Remove rear floor finish plate (see page ir- 31)
  12. Remove reclining remote control lever bezel lh
  13. Remove tether anchor bracket subassembly
  14. Remove deck trim side panel assembly lh (w/ rear no. 2 Seat) (see page ir-32)
  15. Remove deck trim side panel assembly lh (w/o rear no. 2 Seat) (see page ir-32)
  16. Remove rear power outlet socket assembly
    Toyota RAV4. Remove rear power outlet socket assembly

  1. Detach the 2 claws fittings and remove the socket.
Installation
  1. Install rear power outlet socket assembly
Toyota RAV4. Install rear power outlet socket assembly

  1. Attach the 2 claw fittings to install the socket.
  2. Install deck trim side panel assembly lh (w/ o rear no. 2 Seat) (see page ir-52)
  3. Install deck trim side panel assembly lh (w/ rear no. 2 Seat) (see page ir-53)
  4. Install tether anchor bracket subassembly
  5. Install reclining remote control lever bezel lh
  6. Install rear floor finish plate (see page ir- 55)
  7. Install back door weatherstrip
  8. Install rear floor no. 1 Mat support side plate (see page ir-55)
  9. Install rear floor no. 2 Board
  10. Install rear floor no. 3 Board
  11. Install deck board assembly
  12. Install rear floor no. 1 Board
  13. Install tonneau cover assembly
  14. Install package tray trim pocket subassembly
  15. Install rear door opening trim weatherstrip lh
  16. Install rear door scuff plate lh (see page ir-59)
  17. Connect cable to negative battery terminal

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.