Toyota RAV4 Quiz
2Az-fe ignition

Removal

In this manual: 2Az-fe ignition
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
4steps
~24min
2/5difficulty
Done 0 of 4
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove steering column cover lower
Toyota RAV4. Remove steering column cover lower

  1. Detach the 4 claws, release the tilt lever and remove the steering column cover lower.
  2. Remove ignition switch assembly
    Toyota RAV4. Remove ignition switch assembly

  1. Disconnect the ignition switch connector.
  2. Disconnect the ignition key cylinder light connector.
    Toyota RAV4. Remove ignition switch assembly

  1. Remove the 2 screws and ignition switch.

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.