Toyota RAV4 Quiz
2Az-fe ignition

Starter relay

In this manual: 2Az-fe ignition
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
6steps
~36min
2/5difficulty
Done 0 of 6
On-vehicle inspection
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove starter relay
  2. Remove the starter relay from the no. 7 Relay block.
  3. Inspect starter relay
  4. Measure the resistance of the relay.
Standard resistance

If the resistance is not as specified, replace the relay.

  1. Install starter relay
  2. Connect cable to negative battery terminal
    Toyota RAV4. Starter relay

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.