Sliding roof control switch circuit

If either the sliding function or tilt function does not operate, there may be a malfunction in the sliding roof control switch circuit.

1. 1
   Perform active test by intelligent tester (sliding roof operation)
2. 2
   Select the active test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.

Sliding roof ecu

1. 1
   Read value of intelligent tester (sliding roof control switch)
2. 2
   Use the data list to check if the sliding roof switch is functioning properly.

Sliding roof ecu

3. Check wire harness (overhead junction block - drive gear and body ground)

1. 1
   Disconnect the p5 junction block connector.
2. 2
   Disconnect the p6 drive gear connector
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance