Adjustment

1. REMOVE REAR WHEEL

2. ADJUST PARKING BRAKE SHOE CLEARANCE (See page PB-18)

3. INSTALL REAR WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

4. INSPECT PARKING BRAKE PEDAL TRAVEL

(a) Slowly depress the parking brake pedal all the way, and count the number of clicks.

Parking brake pedal travel: 3 to 5 clicks at 294 N (30 kgf, 66.0 lbf)

5. DISCONNECT BATTERY NEGATIVE TERMINAL

6. REMOVE FRONT DOOR SCUFF PLATE LH

7. REMOVE COWL SIDE TRIM BOARD LH (See page IP- 6)

8. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH

9. ADJUST PARKING BRAKE PEDAL TRAVEL

(a) Depress the parking brake pedal 3 notches to make a room for the procedure, and loosen the lock nut.

(b) Return the parking brake pedal to the original position.

(c) Turn the adjusting nut until the parking brake pedal travel corrects.

(d) Depress the parking brake pedal 3 notches to make a room for the procedure, and tighten the lock nut.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

(e) Return the parking brake pedal to the original position.

(f) Check whether the parking brake drags or not.

(g) When operating the parking brake pedal, check that the parking brake pedal indicator light goes on.