Toyota Sienna Quiz
Engine hood / door

Adjustment

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
7steps
~42min
2/5difficulty
Done 0 of 7

HINT:

  • On the RH side, use the same procedures as on the LH side.
  • Since a centering bolt is used as door hinge mounting bolts on the body side and the door side, the door cannot be adjusted with them on. Substitute a bolt with a washer for the centering bolt.

1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY

  1. Check that the clearance is within the standard range
INSPECT BACK DOOR PANEL SUB-ASSEMBLY

Standard

INSPECT BACK DOOR PANEL SUB-ASSEMBLY

2. ADJUST BACK DOOR PANEL SUB-ASSEMBLY

ADJUST BACK DOOR PANEL SUB-ASSEMBLY
  1. Adjust the door forward / rearward and vertically by loosening the body side hinge nuts and bolt.
  2. Tighten the body side hinge nuts and bolt after the adjustment.

    Torque: 19.5 N*m (200 kgf*cm, 14 ft.*lbf)

    ADJUST BACK DOOR PANEL SUB-ASSEMBLY
  3. Horizontally and vertically adjust the door by loosening the door side hinge bolts.
  4. Tighten the body side hinge bolts after the adjustment.

    Torque: 19.5 N*m (200 kgf*cm, 14 ft.*lbf)

  5. Using a screwdriver, remove the back door scuff plate.

HINT: Tape the screwdriver tip before use.

ADJUST BACK DOOR PANEL SUB-ASSEMBLY
  1. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
  2. Tighten the striker mounting screws after the adjustment.

    Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.