Toyota Sienna Quiz
Engine hood / door

Reassembly

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
10steps
~60min
3/5difficulty
Done 0 of 10

1. INSTALL BACK DOOR STOPPER LOWER

  1. Install the 2 stoppers with the 4 bolts.

    Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)

2. INSTALL BACK DOOR BASE STOPPER BRACKET

  1. Install the 2 brackets with the 4 bolts.

    Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)

3. INSTALL BACK DOOR WITH MOTOR LOCK ASSEMBLY

INSTALL BACK DOOR WITH MOTOR LOCK ASSEMBLY
  1. Install the lock with the 4 bolts.

    Torque: 12.5 N*m (112 kgf*cm, 9 ft.*lbf)

  2. Reset the lock

4. INSTALL POWER BACK DOOR TOUCH SENSOR LH

INSTALL POWER BACK DOOR TOUCH SENSOR LH
  1. Install the touch sensor with the clip.
  2. Using a torx driver (T25), tighten the 4 screws.

5. INSTALL POWER BACK DOOR TOUCH SENSOR RH

  1. Install the touch sensor with the clip.
  2. Using a torx driver (T25), tighten the 4 screws.

6. INSTALL BACK DOOR PULL STRAP

INSTALL BACK DOOR PULL STRAP
  1. Install the pull strap with the bolt.

    Torque: 5.0 N*m (51 kgf*cm, 42 in.*lbf)

  2. Install the cover.

7. INSTALL BACK DOOR STAY BRACKET UPPER LH

  1. Install the bracket upper with the 2 bolts.

    Torque: 12.5 N*m (112 kgf*cm, 9 ft.*lbf)

8. INSTALL POWER BACK DOOR DRIVE UNIT

INSTALL POWER BACK DOOR DRIVE UNIT
  1. Install the drive unit with the 3 bolt.

    Torque: 12.5 N*m (112 kgf*cm, 9 ft.*lbf)

  2. Reset the drive unit

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.