Toyota Sienna Quiz
Meter

Data list / active test

In this manual: Meter
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
10steps
~60min
3/5difficulty
Done 0 of 10

1. DATA LIST

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Warm up the engine.
  2. Turn the ignition switch off.
  3. Connect the intelligent tester to the DLC3.
  4. Turn the ignition switch to the ON position.
  5. Turn the tester ON.
  6. Enter following menus: DIAGNOSIS / OBD/MOBD / METER / DATA LIST.

METER:

METER

ABS/TRAC/VSC:

ABS/TRAC/VSC

ENGINE:

ENGINE

2. ACTIVE TEST

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time.

Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.
  2. Turn the ignition switch to the ON position.
  3. Turn the tester ON.
  4. Enter following menus: DIAGNOSIS / OBD/MOBD / METER / ACTIVE TEST

METER:

METER
METER

MAIN BODY:

MAIN BODY

*1: for U.S.A.
*2: Except for U.S.A.
*3: with VSC
*4: with Dynamic Laser Cruise Control System
*5: for Optitron Meter

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.