Toyota Sienna Quiz
Tire and wheel

Enter test mode

In this manual: Tire and wheel
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

HINT:

  • Operation of the tire pressure warning reset switch can be checked in TEST MODE.
  • During TEST MODE, the system is not initialized by pushing the tire pressure warning reset switch. The circuit of the tire pressure warning reset switch can be inspected during this mode.

(a) Make sure that the ignition switch is off.

(b) Connect the intelligent tester to DLC3.

(c) Turn the ignition switch to the ON position.

(d) Check that the tire pressure warning light comes on for 3 seconds and then goes off.

(e) Select the TEST MODE on the intelligent tester.

Enter test mode

(f) Confirm that the tire pressure warning light in the combination meter blinks at 0.125-second intervals.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.