Toyota Sienna Quiz
Axle

Installation

In this manual: Axle
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH

INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH

(a) Install the hub & Bearing assembly LH with the 4 bolts.

Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf)

2. INSPECT BEARING BACKLASH (See page AH-16)

3. INSPECT AXLE HUB DEVIATION (See page AH-16)

4. CONNECT SKID CONTROL SENSOR WIRE

(a) Connect the connector

NOTICE: Do not twist the sensor wire when connecting it.

5. INSTALL REAR DISC

(a) Install rear disc for disc rear brake type.

6. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

(a) Install rear brake drum sub-assembly for drum rear brake type.

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH

(a) Install the rear disc brake caliper assembly LH with the 2 bolts for disc rear brake type.

Torque: 88 N*m (900 kgf*cm, 65 ft.*lbf)

8. INSTALL REAR WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

9. CHECK ABS SPEED SENSOR SIGNAL

(a) ABS WITH EBD SYSTEM (See page BC-3).

(b) ABS WITH EBD & BA & TRAC & VSC SYSTEM (See page BC-72).

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.