Installation

1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH

(a) Install the hub & bearing assembly LH with the 4 bolts.

Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf)

2. INSPECT BEARING BACKLASH (See page AH-19)

3. INSPECT AXLE HUB DEVIATION (See page AH-19)

4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (See page DS-26)

5. INSTALL SPEED SENSOR REAR LH

(a) Install the bolt, connect the speed sensor rear LH.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

• Be careful not to damage the speed sensor.
• Prevent foreign matter from attaching to the speed sensor.
• Do not twist the sensor wire when installing the sensor.

6. INSTALL REAR DISC

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH

(a) Install the rear disc brake caliper assembly LH with the 2 bolts.

Torque: 88 N*m (900 kgf*cm, 65 ft.*lbf)

8. INSTALL REAR AXLE SHAFT LH NUT (See page DS- 26)

9. INSTALL REAR WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

10. CHECK ABS SPEED SENSOR SIGNAL

(a) ABS WITH EBD & BA & TRAC & VSC SYSTEM (See page BC-72).