Toyota Sienna Quiz
Suspension

Installation

In this manual: Suspension
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH

INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH

(a) Install the front lower arm bush stopper to the front suspension arm sub-assembly lower No.1 LH.

(b) Install the bolt and nut to the rear side of the front suspension arm sub-assembly lower No.1 LH.

Torque: 206 N*m (2,100 kgf*cm, 152 ft.*lbf)

INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH

(c) Install the 2 bolts on the front side of the front suspension arm sub-assembly lower No.1 LH.

Torque: 200 N*m (2,040 kgf*cm, 148 ft.*lbf)

2. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR

INSTALL TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR

(a) Install the transverse engine engine mounting insulator with the 3 nuts.

Torque: 87 N*m (887 kgf*cm, 64 ft.*lbf)

3. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT: (See page EM-52)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.