Toyota Sienna Quiz
Supplemental restraint system

Installation

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
4steps
~24min
2/5difficulty
Done 0 of 4

1. INSTALL SPIRAL CABLE

INSTALL SPIRAL CABLE
  1. Check that the front wheels are facing straight ahead.
  2. Set the turn signal switch to the neutral position.

NOTICE: If it is not in the neutral position, the pin of the turn signal switch may snap.

  • Install the spiral cable.

    • NOTICE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

  • Connect the connectors to the spiral cable.

    • NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

    2. INSTALL STEERING COLUMN COVER

    INSTALL STEERING COLUMN COVER
    1. Install the steering column cover with the 2 screws.

    3. ADJUST SPIRAL CABLE

    1. Check that the ignition switch is off.
    2. Check that the battery negative (-) terminal is disconnected.

    CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

    ADJUST SPIRAL CABLE
    1. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

    NOTICE: Do not turn the spiral cable by the airbag wire harness.

    ADJUST SPIRAL CABLE
    1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE: Do not turn the spiral cable by the airbag wire harness. HINT: The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

    4. INSTALL STEERING WHEEL ASSEMBLY

    5. INSPECT STEERING WHEEL CENTER POINT

    6. INSTALL STEERING PAD

    7. INSTALL STEERING WHEEL NO.2 COVER LOWER (25)

    8. INSTALL STEERING WHEEL NO.3 COVER LOWER (25)

    9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    10. INSPECT STEERING PAD (25)

    11. PERFORM INITIALIZATION

    1. Perform initialization.

    HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.

    12. INSPECT SRS WARNING LIGHT

    1. Inspect the SRS warning light

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.