2GR-FE Engine control system

Installation

8steps
~48min
2/5difficulty
Done 0 of 8

1. INSTALL THROTTLE BODY

INSTALL THROTTLE BODY
  1. Install a new throttle body gasket to the intake air surge tank.
    INSTALL THROTTLE BODY
  2. Install the throttle body with the 4 bolts.

    Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

    INSTALL THROTTLE BODY
  3. Connect the 2 water by-pass hoses.
  4. Connect the throttle body connector and clamp.

2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

INSTALL AIR CLEANER CASE SUB-ASSEMBLY

3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner cap sub-assembly with the 2 bolts.
    INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  2. Connect the the vacuum hose (EVAP) to the air cleaner hose.
  3. Install the No. 2 ventilation hose and air cleaner hose band.
    INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  4. Connect the 3 vacuum hoses.

4. INSTALL NO. 1 AIR CLEANER INLET

5. INSTALL NO. 2 AIR CLEANER INLET

6. ADD ENGINE COOLANT

7. INSPECT FOR ENGINE COOLANT LEAK

8. INSTALL V-BANK COVER SUB-ASSEMBLY

9. INSTALL FRONT OUTER COWL TOP PANEL SUBASSEMBLY

10. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.